Stainless steel sink installation method

The first step: see the sink installation process
1, the sink position should be reserved
In the first step, reserve the sink level and provide the approximate size of the sink when ordering the sink. It is best to have a floor plan provided to avoid rework and lead to rework. When the sink is installed, the position reserved for the countertop should match the volume of the sink. The sink should be installed firmly and the tank should not be shaken from side to side. The installation of the sink is not a big project in the whole decoration, but pay attention to the sealing of the joints during the installation process.
2, first install the faucet and inlet pipe
In the second step, the faucet and inlet pipe should be installed before installing the sink. In addition, one end of the inlet pipe on the faucet is connected to the water inlet switch.
3, the sink is placed on the countertop
After placing the countertop, it is necessary to install a matching hanging piece between the trough and the countertop. The sink should be installed firmly and the tank should not be shaken from side to side. The installation of the sink is not a big project in the whole decoration, but pay attention to the sealing of the joints during the installation process.
4, overflow hole, filter basket seal
The degree of sealing of the overflow hole and the filter blue is affecting the use of the sink in the future. Therefore, the degree of sealing of the overflow hole and the filter blue is very important. After the installation is completed, it is necessary to check the sealing of the overflow hole and the filter basket.
5, install supporting hanging pieces
The final step of the installation is to install the matching hanging piece of the sink. After the general sink is bought, the worker will cut the countertop of the cabinet according to the size of the sink. After placing the countertop, it is necessary to install a matching hanging piece between the trough and the countertop. When installing, avoid small gaps and cause the tank to shake to better prevent leakage in the future.
6, drainage test, edge banding
After the installation is completed, a drainage test is carried out, the water tank is filled with water, and the drainage of the sewage water and the overflow hole is tested. If there is any water seepage when draining, rework immediately. After the drainage test, ensure that there is no problem, the sink can be sealed. When sealing with silicone, ensure that the gap between the sink and the table is even and there is no water seepage.

The second step: the sink installation should pay attention to the details
There are several problems in the process of installing the sink. Everyone needs to pay attention to it. Pay attention to the following problems to better avoid the undesirable phenomena during use.
1, the sink is installed in the kitchen renovation
The installation of the sink should be left at the end of the kitchen renovation. The installation of the sink is not a big project. Prepare the sink for the prepared items and install them. After the sink is ready, install the installer directly.
2. The water pipe must be cleaned during installation.
Be sure to drain the water from the water pipe before installing the water tank. If the water is not drained during installation, it will cause water leakage and rust in the water tank in the future.
3, the faucet must be firm when installed
This point is very important for everyone to pay attention to, when installing the sink must pay attention to the firmness of the joint, but also pay attention to the location of the hot and cold water pipe, do not make a mistake. If the installation is not strong, there will be gaps near the sink, causing water leakage.
4, need to be cleaned after installation
After the installation is completed, the sink must be cleaned and the debris during installation should be thoroughly rinsed. In addition, the stains that are easy to see in the daily sink can be treated like this. The sink should be cleaned with warm water, washing liquid and soft cloth after use. The usual stains can be removed immediately; the usual stains such as garbage and cream are slightly polluted and should not be used. Use a strong detergent to clean; foods that easily contaminate the sink, such as tea, coffee, juice, etc., should be washed immediately with water or detergent to prevent alkaline deposits from remaining in the sink.