Daily Care Tips to Reduce Lead Exceeding Hazards

First, the water is learned to ensure healthy drinking water

Experts suggest that when you turn on the faucet every morning, you can put it aside for a while and use it to wash the bathroom and mop the floor. Because the water when the faucet is just opened often carries more harmful substances, such as more lead. In the same way, the faucet that has not been opened for a long time cannot be used for drinking immediately.

Second, the longer the lead, the more precipitation, the regular replacement

Change the faucet regularly. Chlorine is now used as a disinfectant in tap water, and residual chlorine compounds in the water can exacerbate the precipitation of lead in the tap. In general, copper alloy faucets have been used for more than 5 years, and lead precipitation has increased significantly. Therefore, it is recommended that the faucets in the residents’ homes should not be used for too long.

Third, diligently clean up to remove screen impurities

If it is used for a period of time, it is found that the amount of water is reduced, and even the phenomenon that the water heater is turned off may be caused by water and sand blockage in the screen. At this time, gently unscrew the screen cover at the water outlet of the faucet to remove impurities. In general, the impurities of the screen are cleaned regularly for up to three months, which is better for the health of the family.

Fourth, clean the faucet to protect the outer plating

To protect the faucet coating, use a wrung soft cotton cloth to clean it. Do not wipe it with a wet towel to avoid scaling. Do not wipe the coating with burrs. Avoid not letting the faucet touch the acid-base liquid. Spray a neutral detergent onto the soft cloth and gently wipe the faucet.

Fifth, prevent plating aging, use protein insurance

The gold-plated part of the gold-plated product is extremely easy to fall off and lose its luster, and the protein can be used to maintain the gloss of the coating. The protein is beaten to a slightly foaming state with an egg beater, then the faucet is cleaned with warm water, dried, and then a little protein is applied, and the gold plating is gently wiped to protect the gloss of the coating.