♦ When the gas temperature is lower than 0 degree, if the handle of the faucet is abnormal, it must be sprayed with hot water until the feel is normal, otherwise it will affect the service life of the faucet spool.
♦ The dripping phenomenon will occur after the faucet is closed, which is caused by the residual water in the inner cavity of the faucet, which is a normal phenomenon. If it is a long time, if there is dripping in more than ten minutes, it will be leaking, indicating that the product has quality problems.
♦ Due to the trace amount of carbonate in the water, it is easy to form scale on the surface of the metal to corrode the surface of the faucet, which affects the cleaning and service life of the faucet. Therefore, after using the faucet, always use a soft cotton cloth or sponge with neutral soap to wipe the surface of the faucet (note: do not wipe with corrosive or acidic materials), and then dry the surface with a soft cloth. Avoid using wire clusters or scouring pads with hard particles.
♦ Do not use excessive force on the switch faucet. Even a traditional faucet does not require a lot of effort to screw it. In particular, do not use the handle as a handrail to support or use it. Many people are used to deliberately tightening the faucet after using the faucet. This is not desirable. Not only will it not prevent water leakage, but it will cause damage to the sealing valve, resulting in a weak faucet.
♦ The water flow becomes smaller to clear impurities. In the case where the water pressure is not less than 0.02 mpa, if the amount of water is found to be reduced, it may be blocked inside the faucet. The solution is to use a wrench to gently unscrew the nozzle screen cover at the water outlet of the faucet, and then carefully clean the impurities and then carefully install them.